Frequently Asked Questions

About the GeoWash System:

Our concept incorporates the intelligent use of wetting agents, lubricants and surfactants to wash cars. These, coupled with the use of the finest quality applicator towels and highly skilled professionals, will ensure the best results with the minimum resources.

The GeoWash system applies, using a low-pressure spray nozzle, a special formula as a fine mist. We use just the right amount of water: less than half gallon (2 liters) per service.

Other methods uses the “brute force” to wash cars, spilling large amounts of fresh water.

No. GeoWash uses special formulas that lifts, softens, emulsifies and dissolves dirt and other contaminants on contact, while special polymers wrap around any remaining particles in a lubrication film, a thin layer between the paintwork and the dirt, to protect from scratching. Then, the liquid is gently removed using ultra microfiber towels.

The GeoWash process is completely scratch-free. Since we hand wash every car, there will never be any brush, swirl or water marks left behind either.

GeoWash franchisees have been cleaning hundreds of thousands vehicles across the world, including Ferraris, Mercedes, Lamborghinis and many other high-end cars.

GeoWash’s ingredients may include Teflon and Carnauba Wax, high quality waxes and sealant. They form a very hard film over the vehicle’s surface to protect against UV rays, pollution, salt, bird droppings and more.

Our products do not contain any volatile-organic-compound fragrances or dyes, and are non-toxic. What’s more, our products also contain polymers designed to add protection and shine to your car’s surface. Customers will notice a slick surface on their cars once our professionals have wiped them down.

Yes. Your car does not need to be pre washed before using GeoWash and it is safe for dirty vehicles. GeoWash uses high effective cleaners, which easily removes dirt, grime, road film, tar, grease and oil with little amounts of water, without harmful chemicals, or the risk of scratching. Years of experience worldwide prove the quality of the GeoWash system.

To eliminate any risk of marring or scratching the vehicle’s finish, we will not attempt to service heavily soiled cars. We also take pride in leaving nothing behind to show the vehicle were washed, including any type of run-off or dirt on the ground.
An option is to run the car through a regular car wash and knock off the heavy soils. You can then follow-up with GeoWash to shine and protect the surface against heavy build-up again.

Never have to worry about finding or waiting at the car wash again. Customers simply park their cars to have them washed, and we go to the car without customers having to be there or even leave their keys. Most importantly, using GeoWash to clean cars is eco-friendly. Traditional wash methods will use 80 to 140 gallons of water at home and 40 to 80 gallons of water at a commercial carwash.

In today’s society we are seeing a lot of buzzwords thrown into the marketplace. With limited regulation it is difficult for consumers to determine what to believe. We consider our company to be environmentally friendly on several levels:

  • We don’t waste Earth’s most precious resource, water. Our solutions mist on and wipe off, no rinsing.
  • We don’t use high power tools, almost no electricity wasted on washes.
  • We use only biodegradable chemical products.

Washing removes surface dirt and loose contaminants built up from regular driving. Failure to remove these particles can result in potential bonding to the surface. Years of dirt, grime and road film along with sunlight can degrade the finish on a car by way of oxidation. GeoWash saves customers the hassle of having to drive to a wash center, kicks away the bucket with no need for water, buckets, hoses, soaps, suds and water overruns.

Polish is a mildly abrasive substance which sands the surface of paint smooth and allows it to shine. Wax however is a non-abrasive coating that protects the paint finish and microscopically fills in the dents and dimples in the paint to help it shine.

Think of car polish as an exfoliant for cars. Polish contains mild abrasives that remove the micro layer of dull, weathered and dried out paint to reveal a brighter, newer pigment beneath. Now think of the wax as a lotion/moisturizer you would apply after exfoliating to protect the shiny paint/skin from drying out.
The GeoWash wax process provides that deep, lustrous showroom effect.

As well as cleaning cars, it is important to wax them regularly as well. This is because waxing leaves a coat, which protects the paint from the environment as well as leaving a deep, lustrous finish.

About the GeoWash License:

We will provide a comprehensive set of know-how material based on our our operational sites and the ones from our licensees around the world.

Technical, operational, financial and marketing manuals are included along with step-by-step training videos.

We also provide permanent support covering every aspect of the business set up and development.

You don’t need to have specific experience in the car wash industry to become a license owner with GeoWash.

We look for motivated people, customer-service oriented and who have solid management skills. We are also seeking license owners who will be directly involved in the operations and growth of their GeoWash business.

We’ll provide the support licensees need to run the business.

The initial term of your license agreement is five years, with the chance to renew it indefinitely.

If you’re interested in finding out more about a GeoWash International license, request more information about our program.

Or you can contact us at info@geowash.com to receive all the important details you’ll need to make an informed decision.

Designed by Octopus Digital Marketing Agency in Cancún México